Articles

Пожарник (ОГНЕТУШИТЕЛЬ) из воздушных шаров/Fireman (fire extinguisher) from balloons


Hello! Today we will make a fire extinguisher for our fireman …. which we did in previous lessons. So let’s get started. For this we need: — balls for modeling: — 160-1 piece of black color, — 260-1 black pieces, –260–1 piece of gray color, -260– 3 pieces of red color, –360 — 1 piece of red. Getting down. Take a 360 ball. Cut in half. Inflate one part. Inflate until completely, then see the desired size. If anything, cut it off. This will be the basis. Now inflate 260 — 3 pieces. At the end, leave 4 fingers. Tie a knot. Take the first ball. At the end, make a small bubble of 2 fingers. Twist in the ear. Twisted. Now take the base. Hug around. And measure out the desired bubble. Twist with a bubble. Move a little higher. This way. We continue to weave. Make a small bubble of 2 fingers. Now apply. Also hugged. Measured the desired bubble. Twisted. Now hold the small and large bubbles so that they do not spin … thread inside. We connect. And so on. Here we see that just us
fits the ring in size. We immediately knit the next ball. And thread inside. We connect. Continue on. We also try on here. We look that the ring suits us. We tie the next ball. We also make three rings. Here we press the bubble a little .. so that we have a small bubble at the end. All. Now we twist this bubble into the ear. Move the rings a little forward. We can cut the excess here. Gently blow the air. Tie a knot. Now inflate the gray shdm. Tie to the top. We make a bubble for 3 fingers. Twist in the ear. Another 3 finger bubble. Twist in the ear. And one more. Twisted. Now cut the remainder at the end … And leave the bubble on 3 fingers. Tie a knot. Leave a small ponytail. We remove the excess. Now inflate the remainder from the gray ball. Leave a bubble on 3 fingers. Tie a knot. Divide the bubble in half. Twist in the ear. And the remaining bubble is also twisted into the ear. Tied up. We remove the excess. Dress these bubbles …. This way. On the second ring below. Now inflate 260 black ball. At the end, leave 4 fingers. Cut the knot. We make a bubble for 8 fingers. Twist. Now small by 2 fingers. Twisted in the ear. Another 2 fingers. Twisted in the ear. Now 3 fingers bubble. Twist. Another 3 fingers. Twisted. Now make a 2 finger bubble. Twist in the ear. And one more for 2 fingers. Twist in the ear. Now make a 3 finger bubble. We connect with the upper bubbles. And come back .. same bubble for 3 fingers. And we connect with the lower bubbles. This is how you should be able to. Now cut off the excess and leave the bubble on 4 fingers. Tie a knot. Correct … so that you have such a design. The long bubble is slightly bent. This way. So we made such a handle. Now take the tail on a gray ball and …. wrap around. Now it remains for us to make a hose. Inflate 160 ball for modeling. Leave a small ponytail. We don’t need the whole ball. Tail … tie to the gray bubble. Like this. Now measure the desired bubble. In such a way that we get a hose in the form of an ear. Measured. Twist. We connect with the gray bubbles below. We remove the excess. Tie a knot. Now we are correcting everything. Here we have made such a fire extinguisher. That’s all for today. Thank you all for your attention!) Be sure to SUBSCRIBE to my channel !!!))) Until we meet again!) Bye – bye!)))))

Leave a Reply

Your email address will not be published. Required fields are marked *